Installation

Fully read and understand the directions before installation. Refer to additional safety information at the end of this document.
  1. Turn off the circuit breaker to the NEMA 14-50 outlet or hardwired electrical connection.
WARNING: Do not continue this installation until the circuit breaker is turned off.
  1. Use a wall screw (x1) to secure one side of the wall bracket into the stud closest to the installation area. Use a beam level to ensure that the bracket is level horizontally, then use a wall screw (x1) to secure the other side of the bracket into the wall.
    NOTE: Mount to wood, a stud, or use concrete or dry wall anchors.
  2. Use the enclosure screws (x4) to secure the enclosure bracket onto the back of the JuiceBox.
  3. Hang the JuiceBox onto the wall bracket.
  4. Optional: Use a wall screw (x1) to secure the bottom of the enclosure bracket to the wall.
  5. Connect the JuiceBox to the hardwired connection:
    • Plug-In Version: Plug the JuiceBox into the NEMA 14-50 outlet.
      WARNING: Do not use this device with an extension cord.
    • Hardwire Version: Connect the pigtail harness to the wiring terminal:
      Red Black Green
      L1 L2 Ground
      NOTE: No neutral (white) line is used.
    CAUTION: Do not use wire nuts. They might melt at high current.
  6. Turn on the circuit breaker that supplies power to the JuiceBox. Wait 10 seconds.
    Verify that the JuiceBox is powered by checking that the "Power" indicator light on the enclosure is solid green.
  7. Install the charging cable holder.
    NOTE: Mount to wood, a stud, or use concrete or dry wall anchors.